Skip to content

TV Antenna Installation in Perth

Corrosion-resistant masts, quad-shield RG6, additional outlets and a clean, tuned picture on every install.

  • ACMA-registered cabler · T62021
  • Fully insured
  • 12-month workmanship warranty
  • Local, Perth-owned
  • Free, no-obligation quote

[ What we do on the day ]

A clean, methodical install

  1. 01

    On-site assessment

    We inspect your existing aerial, cabling and outlets and check how each TV is performing — so the fix suits your actual setup, not assumptions.

  2. 02

    The right aerial, mounted to last

    We install a quality digital/HD antenna on a corrosion-resistant mast at the correct height and alignment for a clear line of sight to the transmitter.

  3. 03

    Clean cabling & extra points

    Quad-shield RG6 is run neatly to flush F-type wall plates in the rooms you want — bedrooms, study, alfresco — with no cable on show.

  4. 04

    Boost only where it's needed

    If signal is genuinely low we fit a masthead or distribution amplifier — but only when the job calls for it, so we lift the signal without amplifying noise.

  5. 05

    Checked & handed over

    We check every outlet, tune your TV if needed, tidy up, and confirm a stable picture before we leave. Backed by our 12-month workmanship warranty.

[ What's included ]

Every job, as standard

  • Digital/HD antenna supplied & installed
  • Corrosion-resistant mast & marine-grade fixings
  • Quad-shield RG6 coaxial cabling
  • Additional TV outlets on flush F-type plates
  • Masthead / distribution amplifier where required
  • Outlet checks & TV tuning
  • Full clean-up + 12-month workmanship warranty

[ Why it matters here ]

Built for Perth conditions

Perth's coast is hard on aerials

Salt air and coastal winds corrode old antennas and connections far faster than inland — especially in suburbs like Hillarys, Sorrento, Mullaloo and Quinns Rocks. Corrosion-resistant hardware and properly sealed connections aren't a luxury near the coast; they're the difference between an install that lasts and one that fails in a few years.

A growing skyline and tall trees

New developments and mature tree cover across the northern suburbs can block or scatter signal that used to be fine. Getting mast height and aerial placement right matters more than ever — and it's why we assess each home on site rather than fitting a one-size aerial.

[ Free quote ]

Get a quote for tv antenna installation

Tell us a bit about the job and we'll come back with a clear, no-obligation price — usually the same day. Prefer to talk it through? Call AJ on 0416 831 786.

  • ACMA-registered cabler · T62021
  • Fully insured
  • 12-month workmanship warranty
  • Local, Perth-owned
  • Free, no-obligation quote

Protected by spam filtering.

We'll only use your details to respond to your enquiry. No spam, ever.

[ FAQs ]

Common questions

Do I still need an antenna if I have streaming?

Many people keep a TV antenna alongside streaming because free-to-air channels (ABC, SBS, Seven, Nine, Ten and their sub-channels) carry live sport, news and events with no subscription, no data use and no buffering. An antenna is also more reliable than streaming during internet outages. If you watch any free-to-air at all, a working antenna is worth having.

How much does TV antenna installation cost in Perth?

It depends on the aerial type, mast height, how many TV points you want and roof access — so we give a clear, no-obligation quote up front, after we've assessed the job. A standard single-storey antenna replacement is our most common job; extra points, double-storey access or amplifiers add to it. You'll always know the price before we start.

Can you repair my existing antenna instead of replacing it?

Sometimes. If the aerial itself is sound and the problem is a corroded connection, a failed amplifier or damaged cabling, a repair may be all you need — and we'll say so. If the aerial is corroded or outdated, replacing it is the more cost-effective fix than repeatedly patching it.

Why is my picture pixelating or dropping out?

Pixelation usually means a weak or noisy signal — common causes are a corroded or ageing aerial, water in the cabling, a failing amplifier, or tree cover that's grown over the line of sight. We track down the actual cause on site so we fix the real problem rather than just swapping parts.

Get a free, no-obligation quote

Tell us what you need — we'll give you a clear, no-obligation price. Most quotes the same day.

  • ACMA-registered cabler · T62021
  • Fully insured
  • 12-month workmanship warranty
  • Local, Perth-owned
  • Free, no-obligation quote
Call 0416 831 786 Free Quote